Ryobi Battery Cap (High Power)

thingiverse

This is a re-designed Ryobi battery holder, specifically designed to use the "300001044 RYOBI/RIDGID - Contact Plate Holder Assembly." (photo 1) I'm using these for a motor controller and need a 10-12 gauge wire for any quick power / amperage draw. The leaf spring connectors for the old version had a tiny solder point and I just couldn't get any type of good connection. These work nicely with Female Spade Wire Crimp / Nylon quick disconnect connectors. Because of the height of the connector assembly, and a desire not to have to glue things, this is designed to use a zip tie (4.5-5mm wide) to hold the connector to the adaptor. There is a curved channel for the zip ties and they basically sit on top of the battery with a nice firm fit. Once printed, remove the brim, pop in the connector and zip tie on. Add wires and done! **Parts list below:** Below are the parts and materials I used as a reference. These should be direct links (not affiliate). * 300001044 RYOBI/RIDGID -- $1.54 each at Small Engines Pro Dealer (best deal I found) -- https://www.smallenginesprodealer.com/part-ryobi-300001044/ * Microcenter Inland 1.75mm Black PLA+ 3D Printer Filament - 1kg Spool (2.2 lbs) -- $19 @ Microcenter -- https://www.microcenter.com/product/611532/inland-175mm-black-pla-3d-printer-filament-1kg-spool-(22-lbs) * TICONN 100 Pcs Nylon Spade Quick Disconnect Connectors Kit, Electrical Insulated Terminals, Male and Female Spade Wire Crimp Terminal Assortment Kit -- ~$10 on amazon, probably also available at local home improvement store -- https://www.amazon.com/dp/B08BZ972B5 * Zip Ties... -- $3.99 -- I picked these up at Target