S.T.E.V.E X Gantry for 10mm rod and IGUS RJZM

thingiverse

Made for IGUS 10mm aluminium rods, can use steel and or rods etc. use this clamp: X_Gantry_Bearing_Clamp_0.01 from CRT's original design. Note: this uses 8mm rods for the Y axis, and 10mm for the X axis! Igus RJZM-02-08 bearing for the Y rods, Igus RJUM-02-10 for the carrier. (fits the bearing clamp, it's a tight fit but with a bit of force it should slide in) Update! For those that have used this with the End stop mounts I made please download the model again and print it out if you have issues with the belts not aligning quite right aswell as the X-end stop switch getting twisted over time. I've updated the design to have a taller model to work as a striker for the X-endstop switch. Also use A and B type of these instead of the older bigger types: https://www.banggood.com/16T20T-GT2-Aluminum-Timing-Drive-Pulley-For-DIY-3D-Printer-WithWithout-Tooth-p-1099142.html