SAF 8" FPV frame

thingiverse

8 Inch - https://www.cncdrones.com/SAF-8-inch_p_1128.html 9 Inch - https://www.cncdrones.com/SAF-9-inch_p_1140.html Short version has a 20mm shorter front for better protection but requires high camera tilt to get props out of view Long nose gets props outta view around 20-25 degree on Hero10 with 8" props Short version will be hard to get props outta view on 9" version.. 40 degreeish im guessing - CF parts 1 - 8topplate or 8topplateshort in 3mm (0.5mm chamfer outside/battery strap slot on both sides) 1 - 8bottomplate or 8bottomplateshort in 3mm (4x m4 pressnuts installed, 5x m3 pressnuts installed) 1 - armplate in 3mm 4 - 8incharm or 9incharm in 8mm Also got thinner 8incharmlongrange in the dxf's - Hardware 10 - m3x20mm standoff 16 - m3x8mm 20 - m3x12mm (16 for motors, 4 for gopro mount) 4 - m4x16mm 4 - m3x30mm for FC/ESC 1 - m3x16mm for center bolt where legs meet 4 - m4 pressnuts 5 - m3 pressnuts - 3d prints 2 - airunitcameramount (one mirrored) 1 - capholdernew (fits a 50v 1000uf i have, sure makes esc soldering easy) 1 - reardualantennamount 2 - airunitholdernew (one mirrored) 2 - immortal t or 1 matekantenna for matek elrs antennas 1 - GoPro 10 mount, i designed 20/30degree versions with lens protected versions of each, mounting is 32mmwidex40mm long Recommended motors - 2809 1250kv or 3008 1150kv for freestyle, 3106 1200kv for light longrange Recommended batteries - GNB 2600, 3300mah, 4200mah 6s Designed to use 20cm camera cable for air unit/vista in rear, although there is room in front w/long nose version for airunit to be taped in if out of 20cm camera cables Shout out to Straw Hat Sam for the center bolt arm locking idea, start the 2 outer bolts on all your arms first(leave em loose) and leave the center bolt last... it will be tight but should start threading into carbon/pressnut(i use socket head for first install to get the extra torque of a 2.5mm head) Im careful when it starts to hit pressnut to makesure it threads in good, might take some backing out and in for a bit to feel a clean start. Sometimes arms might need to be filed at the center bolt if its too tight, i disassembled one proto and used a small round file