saitek pro flight yoke system desk clamp

thingiverse

I like flight simulators, im trying to get my pilots license so with that i like to practice with controls as close to the real deal that i can get, i found this yoke online but no desk clamp and with some issues with the manufacturer these yokes are not available new at the moment. so i got this yoke and made up my own clamp. its a snug fit and the bolt holes on the ends are more of a suggestion plus the holes are not exactly lined up, close enought to clean up with a drill bit or use a smaller bolt.the center hole itself you can get a bolt and nut from the hardware store to finish off the clamp. i seen no point in trying to 3d print adjustment bolt when a steel one would be much more reliable. 20% infill total print time about 19-20 hours. on my axiom about 6 1/2 hours for each piece. hope this helps