Samsung Galaxy Buds Pro/Live Holster/Holder w/ Clip

thingiverse

Simple holster/holder for a pair of Samsung Galaxy Buds Plus or Live. Can be put on straps of many kinds, like backpacks, or my favourite; belts: Size: The normal size is specified to have some friction between the buds case and the printed holster. This friction can vary depending on the printer at use and your slicer settings. It is recommended to scale up or down the model in your slicer if you want to have more or less friction. Magnets: If wanting to use magnets, upscaling the model will probably have to be done. Roughly 1-3% from my experience with this and other, older models. This will ensure there will be less friction since the magnets will do the work of holding the buds in place. For optimal performance, use two magnets. The holes I've set for magnets are 11 mm wide and 3,2 mm deep. The magnets I have used are 10 mm in diameter, and are 2,5 mm wide. Also note; DO NOT place the buds case in the 3d printed holster for a short period of time after gluing the magnets to the model. Some glues will release visible substances that you do not want on your Galaxy Buds case. Printing settings: For this model, I recommend printing it on its side with supports from buildplate only. Make sure the underside of the base and the clip gets proper support. The smaller layer height, the better finish on the sides, but other than that, the rest will look fine. For reference, the model in the pictures are printed at 0,3 mm layer height. NOTE: For the perfect fit for your liking, you might have to print multiple of these. A fit that is too small can cause visible wear on the case, and a model that has been scaled up too much can cause the buds to fall out too easily. All printers and settings are unique, trial and error, there will be. Please message me for suggestions (flaws, other changes, customisations, etc), or questions.