Samsung Galaxy Note 3 wall dock

prusaprinters

<p><strong>NOTE</strong> I've noticed the newer usb cables have two little ribs for grip on the phone end. When I designed this dock, my old cable was perfectly smooth and didn't have these ribs. So when the cable went bad and I had to get another one, I used a razor blade to slice off the two little ribs. That way the new cable would fit easier during installation into the dock. You may have to do the same seeing how it was designed for use with the older smooth type usb plug.</p> <p>I made this phone dock for myself personally, so it may not fit your needs. My phone has a Spigen Neo Hybrid case on it, so all measurements were done with the case on my phone. So a naked Note 3 will fit in this dock fine, but with a tad bit of slop. You may have to make shims if your not happy with the play. I also included the measurements in the picture, just in case you want to measure your case to see if it will fit in this dock. Sorry if the measurements look confusing, they are for the actual I.D. of the slot where the phone slides into. If your case/phone are equal to or smaller than the measurements, then it should fit. USB cable fitment into the bottom of the phone may vary depending on the thickness of your case at the bottom of your phone. This dock was designed to use the stock Samsung 2.0/3.0 usb cable. I just figured I'd upload this design just in case someone could make use of it besides myself.</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>FlashForge</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>Dreamer</p></div><strong>Rafts:</strong></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div><strong>Resolution:</strong></p> <p>.200 is what I used.</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>65% is what I used.</p></div></p> <p><strong>Notes:</strong></p> <p>I printed mine out of wood PLA. The holes are recessed in the rear 1mm to compensate for the lip on a drywall anchor.</p> </p></p></p> Category: Mobile Phone