Samsung Galaxy S6 Case

prusaprinters

<p>This is a design I made inside of Blender. The back doesn't go all the way through, it's only imprinted a little bit (water doesn't even seep through). I would recommend using ninjaflex as your filament, I am not sure if it will fit if not made with stretchy filament.</p> <p>Also, make sure when you put it in the case you put the top (with the camera) in first and then the back. The bottom is a little more fragile than the top so be careful with it.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Printrbot</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Simple Black</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Infill:</strong></p> <p>35%</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Make sure to print it very slowly, I did it at a speed of 15 because otherwise the ninjaflex does not come out as well. </p></div> </p></p> Category: Mobile Phone