Samsung Galaxy Tab S7 Cradle with RAM B compatible ball

thingiverse

Designed to hold a Samsung Tab S7 tablet without any casing and without pen, i.e. for use in a car on a bicycle or areoplane. It is your responsibility to secure the device against crashing down. Be sure it cannot block your actions to control the vehicle in any way. The hole in the RAM_B_on_plate is meant for a metrical screw to be glued in with high quality epoxy. Doing so will create the necessary strengh so the RAM ball does not fall off at first attempt, so don't use this without the metal screw inside :-) Secure against falling off, i.e. by use of the 4 "button" holes, to secure straps that can be attached with small metal holders to secure the tab in place against top and bottom. I don't use that, so no picture of the design, yet. Printing: I printet all in snow white PLA. Snow white so it doesn't absorbe radiated light and creates warmth. Works on in german summer environment, but be aware that with ambient temp >50ºC, you'll loose function with PLA. Comment please if you succeed with ASA or similar to create higher temp. stability! use loads of infill, i.e. 90% to create stability for the cradle, you may experiment with less here. always use 100% infill for the RAM_B_on_plate, otherwise you'll fail for shure. use rubber coating to coat the RAM_B sphere, this makes it less slippery, find it on ebay.