Samsung NC10 LCD Panel Conversion

prusaprinters

<p>I had an old defunct Samsung NC10 Netbook. It pretty much was dead however I couldn't bring myself to just throw it away. I stripped it for parts and obviously had the LCD panel. The NC10 had a basic 1024x600 10.2" LCD panel and after a quick search online I found one of those driver boards. I brought one and then had to figure out a way to use it.</p> <p>My old Amiga has recently resurfaced and this would make an ideal little monitor for use with it. I have designed an enclosure for the panel that mimics a "proper" monitor. The final design has both tilt and up/down adjustment (the latter is more for fun as it only lifts by ~20mm).</p> <p>Another "just for fun" is the inclusion of my pretend company name 'qtone', a name which I include on all my audio/video projects. There is a small logo on the front chin bar and a larger one on the rear. Just gives it a finishing touch. Although these are designed to be printed using multi-material printing.</p> <p>The design just about fits on the MK3S build plate!</p> <p>Port wise the driver has HDMI, DVI and VGA video inputs, a 3.5mm jack audio input and another for audio output. It runs from a 12V supply and provides 5W's of stereo audio as well. The monitor has provision for two speakers on the rear.</p> <p>For some reason the website is not allowing me to upload the Sketchup file. Message me if you wish to have a copy.</p> <h3>Print instructions</h3><p>Print off the parts. Some parts are designed to be printed with 2 extruders but can be printed with only one, there are:</p> <p>front-case-clip-supported.stl and front-clip-case-logo-supported.stl<br/> rear-case.stl and rear-case-logo.stl<br/> case-cover.stl and case-cover-inlay.stl</p> <p>If using single filaments just omit the "logo" or "inlay" stl files and it should be okay. There are no large overhangs to cause an issue.</p> <p>I have updated the front case to have clips to hold the screen in place. This removes the need for the stand-offs that were used to make sure the screen was held at the front of the case. These obviously overhang and there are supports built into the model.</p> <p><strong>Non-Printables</strong><br/> 6no - 2mm x 12mm self tapping screws<br/> 14no - 3mm x 6mm self tapping screws<br/> 4no - 3mm x 9mm self tapping screws<br/> 1no - 20mm M8 bolt<br/> 2no - M8 washers<br/> 1no - M8 nut<br/> 4no - 10mm diameter x 2mm thick self-adhesive rubber feet</p> <p><em>Optional</em><br/> For Speakers<br/> 8no - M3 10mm screws<br/> 8no - M3 nuts</p>