Samsung S7 Edge case

thingiverse

I'm not really keen on the flip cases for mobile phones because I can never hold them with the cover folded right back. Also, the S7 Edge one has a swipe hole... and a point that pocket contents such as car keys can get in and scratch the screen... which is curved, so there is no effective tempered glass full-screen protector. This is a solid case for a Samsung S7 Edge. It has magnetic locks (you'll need 3mm diameter by 2mm thick, N42 is good), and it doesn't have a window for swiping your finger or your car keys to gouge the screen through. You can put the lid in your pocket while you're using the screen. The first layer has the Voronoi cut out and as it's printed on glass it's smooth so the next layer contrasts really well. The one in the images was printed in metallic gold nGen from ColorFabb. It's really quite light weight (with a hexagonal internal structure to remove plastic) and doesn't add a great deal of bulk (about 3mm) WARNING If you do print this on glass, the case is REALLY smooth and I can confirm that this case has protected my phone from 2 falls out of my pocket as I've gotten into my car, and one trip and throw. Obviously, I cannot rate it for your accidents :) VERSION 2 now available (silver in the photos) Well, ok, it's labeled v4. I found that in the dropping I lost a few magnetic corners, and the case split a little between the power and volume button, so I beefed it up a bit. As a consequence, I have not dropped it once yet - possibly due to the inner curve and squarer edges. This design is not for everyone, but it works better than the original for me. Also I rounded off some of the holes, and made a recess for a large heaphone plug. Print Settings Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: No Supports: No Resolution: 0.2mm Infill: 100%