Samsung tab s6 stand with pogo pins

prusaprinters

<p>This stand has cutouts for pogo pins (small cobber pins with build in springs) that connect to the 4 small, round cobber plates in the bottom of the tablet.</p> <p>On the pictures you can see i used some double sided tape to fasten the mount to the table. This is just to keep it from sliding around when i insert the tablet. its not needed.</p> <p>When facing the tablet screen, the left pad is +5v and the right most is ground. I just used an old usb cable and cut the one end off, and then soldered the wires to 2 pogo pins. Then used a glue gun on the bottom of the pins to act as isolation and protection.</p> <p>Its not fast charging, actually its pretty slow charging, but its enough for me.</p> <h3>Print instructions</h3><p>print on the side. Use pla :)</p>