Scallion Keeper-Fresher (Spring Onion)

thingiverse

This design is to keep Scallions (Spring Onions in the UK!) fresher for longer using a reservoir of water and to grow their roots into more that can then be planted in compost to grow an unlimited supply of Scallions! Printing: Printed in amazon Basic PLA (green/Neon yellow) 215C/55C with Got2B Glued hairspray. Base - 100% infill and 2/3 walls to hold water, recommend a thin coat of varnish to ensure water tight, heat treating warps the parts making a bad fit. Frames - minimum of 2 walls and 100% infill for 1 and maybe 2, 20% infill for 3 to speed up printing. Support - 4 needed to fully support the frames, reduce size to 98% to ensure a good fit with all the parts, 2 walls and 10-20% infill works fine, brim recommended. Full print with is 1500mm x 1350mm x 1990mm and holds 19 Scallions or 23 for roots only sans frame and support Supports and frame can be glued in place, not recommended but could help if plastic is weak or thinner than expected.