ScanGaugeII Dashboard Mount

thingiverse

Dashboard mount for holding a Linear Logic ScanGaugeII. General Information Light friction fit, with a 15 deg back angle for easier viewing. For off road use, you could optionally install double-stick tape or thin Velcro in the bottom to hold the gauge into the mount if desired. Limitations No mounting screw holes. You can drill your own holes if desired, or mount to dash using contact adhesive (good quality RTV silicone generally holds well but will still peel off later if needed; Household GOOP will also work). The original design exposes the side OBD port on the ScanGauge and blocked the rear. This "v5" file has a cutout for the rear port, but requires supports to be turned on when printing. Print Settings Printer Brand: MakerBot Printer: MakerBot Replicator 2X Rafts: No Supports: Yes Resolution: 0.2mm Infill: 40% Hex Notes: Test prints were done using blue ABS, 40% hex infill, no raft or supports. Printing directly to the bed leaves a smoother bottom surface for better adhesion to the dash if using silicone.