Sci-fi Retro Rocket-low poly fun!

thingiverse

I have always loved rockets and designed this for a little fun. It is a small print, but a good challenge for a filament printer. This design will print without support on a well tuned filament printer. The plume is a challenge because of the tiny base, but use a brim and just trust that it will harden enough after the first quarter inch to support the rest of the print. You can also print multiple rockets and plumes, so the filament will have time to stiffen up a bit before the next layer. The picture shows it blasting through the Peach Planetoids! Instructions After printing, trim up the plume base and rocket nozzle. Add a drop of glue and attach them together. Go play!