Scope Rings, 1 Inch with Picatinny Rail Mount

thingiverse

Since I had the rail, I felt like adding some rings. There are two sets of rings, a ~25mm size with two sets of machine screws, and a longer, ~35mm set with three sets of machine screws. I test fired these with my Hatsan 125 air rifle and it held up. I haven't gotten the check how well these will hold a zero yet. My first set seemed a little off centerline when I dropped the scope in, which is why I made the second, longer rings. Update 1/21/15: New file added for my "zip grip" variant, which allows the use of zip ties instead of metal screws to afix the ring base to one of my rails that include slots for zip ties. I included a picture. Firing tests have had the rings hold up, but not the rails, at least when made from PLA. I would think that would mean ABS is a no go to. I plan on starting to figure out PET+ pretty soon, so I hope that will make these parts functional. If not, you can still use them to mack out your nerf guns and super soakers. Instructions I print the rings laying down cross-wise and the cleat from the side. I used 6-32 machine screws for securing the top of the ring the base. The square rod with the threaded end, I have no idea what it is. If you know, leave a comment, I salvaged it from an old red dot scope I had laying around. With that being said, a long thin machine screw and wing nut could to the same thing.