Scope Throw Lever - SWFA SS HD 5-20x50

thingiverse

This is a Throw Lever for an SWFA SS HD 5-20x50 scope. It may fit some of the other SWFA scopes with 30mm tubes. This requires a single small screw - you'll likely need to drill the pilot hole to the right size. Print Settings Printer: Anet A6 Rafts: Doesn't Matter Supports: No Resolution: 0.2mm Infill: 100% Notes: This prints fine without any supports Post-Printing You'll need a small screw to complete this.I'm using a small 8x1mm stainless screw, but anything tiny should work, just drill out the pilot hole to fit. This will only fit onto the zoom ring one way - The smaller diameter smooth ring faces back towards the rifle stock. You will need to slightly stretch the ring open to get it in location - The smaller diameter smooth part stops the throw lever from being able to slide off the zoom ring.