Scott Scale Seatpost light (MTB bike)

thingiverse

Hi all, This item is designed for a special purpose. I have a Scott Scale bike with a dropper post, sadly when this one go down there is no place for my LEZYNE LED ZECTO DRIVE 80. This kind of elastic strap rear led need to be attached to the seat tube, if i push it down i can loose it at any moment :-/ Happily my Syncros (Scott) seatpost have 2 female screw under it. With this design i can fix a small tube (6cm) to attache my light without any chance to loose it on the trail. Because of the tube design i also integer a small storage compartment. The screw is tight after printed it but after a few screw / unscrew session that ok. You can add an o-ring inside the cap to make it 100% waterproof. This storage is enought to store dog crap bag, repair tube, money ... You can add support in cura for a better result but you have to take your time to get it off due to the tube design, the support will be around the tube and cutting it is hard (PLA). I tried this without support and the result is pretty the same at 0.12. The tube is long enought to add a light and a bell. Not a must have on a MTB Bike but for some trails needed so i can use it with one hand sometime.