Scraper - 200 mm long

thingiverse

I was just printing and two of my parts didn't work out. I ended up getting some strings on the good part and because I can't get my fingers let alone my hand in there, I had to make a new longer scraper to help me with this if it comes up again. I also can't get my hand through the top as the cb is in a shelf so this will hopefully help. Instructions This is a simple extrusion for a scraper. Nothing special, I just needed a longer one this time. As you can see I like to keep my stuff simple or as simple as I can. It's 200mm long, 4 mm thick and 20 mm wide. I will be printing it next once my current print gets done. I noticed that printing these on medium or higher is best. Also print this on it's side instead of flat as the layers will be smooth. If you print it flat you will have steps instead of the nice smooth angle. Use a small brim to keep it in place and you should be good. I just tried printing it flat and I get steps. I printed the small one on its side and it's smooth on that angled side.