Screw cutting support for "Rod and Tube Cutter for Dremel" v2 with finger protection

thingiverse

This is an upgrade for the "Rod and Tube Cutter for Dremel" by GreaseMonkey88. Please also check the source creator. I always wanted a support for straight cutting, not only for tubes, rather screws. This is it. It fits perfectly in my printed "Rod and Tube Cutter for Dremel", It doesn't wobble a bit. The the possible minimum length is around about 5 mm. ATTENTION: Actually you have to hold the screw with your own Finger. At such short screws, please pay attention to your fingers! Use this attachment at your own risk! I also uploaded all the files, I used for my "Rod and Tube Cutter for Dremel", so you have the compete project. - Base_38 - Guide_38 - Bolt_38 (my own creation :-) - Screw cutting support (this creation) EDIT 2020.03.25: Due to security, I have created version 2, which includes finger protection. Uploaded the BLENDER file, which contains both versions for the support to cut screws. See the pictures by there is a drawing with the possible diameters. The holes are prefabricated up to a maximum of 8 mm, and I think relatively safe to cut off. The old one was just with a v-cut. EDIT 2020.04.12: Attention, if you saw or grind for too long, screws and pipes become very hot and the plastic melts!