Screw on Headphone Stand - Slightly Over Engineered

thingiverse

This is a reworking of my previous Headphone Stand: https://www.thingiverse.com/thing:3355293 but slightly over engineered. The simple mortice joints have been replaced with dovetail joints. These will have to be printed with supports to be accurately printed. I designed this headphone stand to fix ON the edge of a table, be able to hold your headphones without taking up any table space. Note, the screw is designed to simply fix the stand to the table, so almost no pressure is needed on the screw - in fact you would damage the structure of the stand by clamping it too tight. The design should be suitable for any headphone - mine happily hold a pair of Audio-Technicas and a Sennheiser HD600. EDIT: This design works AMAZINGLY well, if you stick a little rubber surfacing to the underside of the top support - the one that will touch the table top. PLA has a tendency to be very slippery when printed, so tightening the clamp didn't really stop it from moving. I bought some $1 rubber non slip material from a dollar store and stuck it on with some glue - with brilliant results