Screwless NES Pi 3 Case with Fan

thingiverse

** Updated the clips since some folks were saying they were a bit too short ** This is my first submission! I decided to mix the two cases I liked the best on Thingiverse into one. First off thanks to LKM, his design is amazing, but took ages to print on my Monoprice mini. https://www.thingiverse.com/thing:1887826 I then really liked the smaller screwless design of xxxMTIxxx's, but the top and bottom moved around from each other and didnt have a tight fit (at least that was the results on my mini). https://www.thingiverse.com/thing:2379204 I decided to put the 2 together. using xxxMTIxxx's design I added a fan in the top but used LKM's clip and side structure. The end result was a well fitting sturdy case, that i can print much quicker on my Monoprice Mini. Be sure to gently remove the temporary plate supports on the band side on the top and bottom plates for the clip cut outs. Here is the fan and heat sink's i used http://amzn.to/2hfCOxd I added a new logo to the lid, but as of yet i havent printed it. Let me know what you guys think. Be very careful with the fan stand offs, they are not very strong and I might update them in a later revision.