Scroll Wheel for 'Man & Machine' Washable Mouse C-MOUSE W5

thingiverse

This is a replacement Scroll Wheel for the Man & Machine C-MOUSE W5 Washable Computer Mouse. The original wheel is pretty low quality and the peg often sheers off at the encoder. (Open the mouse and pop the remaining piece of plastic out of the encoder hole before reassembling and installing this replacement!) To open the mouse: -Remove the single screw on the underside and unclip the top cover. -Remove the 6 screws under the small white rubber caps inside the mouse -Locate the encoder for the mouse wheel and use a pin or something small to push the remaining piece of plastic from the original wheel out the other side. -Reassemble the mouse and install the new wheel into the slot/encoder (this can be a bit fiddly until you get the angle right) Print Settings: -30% Infill -Supports (Touching build plate Only) (Takes approx. 25mins to print on an Ender 3)