SD2IDE 44-pin 2.5" HDD Enclosure

thingiverse

This is a 2.5" hard drive enclosure/cradle made for the widely available SD2IDE you can find on Amazon, eBay or [the OSVG Store](https://store.osvg.net/?product=sd2ide-44). A bit about the enclosure: - This was created to fit inside the IBM ThinkPad 701C Hard Drive Caddy, but this will fit ANY IDE form factor. - The screw hole locations are of an older IDE HDD - pre 1995 I believe. These also may not matter if you don't plan on screwing it in or if you're also using a laptop caddy. - This is for the 44-pin version of the SD2IDE version ONLY - I made this so you can easily replace the SD card without taking it out of the caddy - There are 3 holes sized to take a M3*4 knurled nut (as shown in the pictures) Tip: I use [Bondic UV Plastic Weld](https://www.amazon.com/stores/page/3954B8E8-4B85-45AF-8ED2-CC807DEDC0E2) on all 4 corners to fix the SD2IDE in place. Cures in seconds with the UV light and it is VERY strong. Enjoy!