Sea Serpent

prusaprinters

<p>This is my print of Sea Serpent by 7Fish full information available here: <a href="https://www.thingiverse.com/thing:2744865">https://www.thingiverse.com/thing:2744865</a></p><p>I warn you this is a challenge, make sure you print and assemble in the correct order as the parts are not labelled and gradually increase in size, also I found I had to sand all the male parts of the ball and socket joints and lube them to get them to connect, you will also need to wear gloves as the sections have sharp point on the back</p><h3>Print instructions</h3><p>Rafts: Doesn't Matter<br>Supports: Yes<br>Resolution: 0.2<br>Infill: 10%<br>Filament: Prusament Mystic Green (needs 5-10ºC higher than recommended)</p><p>Notes from the designer:<br>1) Please be careful not be confused between sets and parts, part number is not engraved.</p><p>2) Body Segments without prebuilt supports are in Zip File. Please Don't change-oriented Direction to vertically, it reasons are to protect the ball from strain under the socket and scales that may can break off</p><p>3) Assemble Tail tip 02 (Flat tail fin) will need glue to put together</p><p>4) if you have trouble the ball into socket, grind or shave ball's top and bottom about 1mm and try again.</p><p>April 7 2018 replaced file with minor fix.</p><p>How I Designed This<br>This snake is consists of Head (Jaw, Tung, Eye) and body (limb upscale by 103% each which Tail set 20-21 and limb down by scale 98% each which Tail set 22-31 and Tail Tip.</p>