Segmented Dice Tower

thingiverse

This dice tower was inspired primarily by my work on https://www.thingiverse.com/thing:4608953 However, this model was created from scratch (not a remix) to allow for: ...Printing without supports ...Making it printable on smaller machines ...Disassembly for transport ...The flexibility to have short to freakishly tall towers **WARNING**: The two "complete" models should not be printed as-is. Supports are required for the battlement (because of it's flat roof) and because it is a closed mode, you will not be able to get inside of it to remove any supports you may add. That being said, they have been successfully printed without support, relying on the PLA to bridge the gap and eventually create a solid roof/floor. To print, start with the base, top and battlement. You can later print as many middle sections as you like, each one adding 60 mm to the height, and rotating the battlement 96 degrees.