Self-draining Succulent Planter

prusaprinters

<p>No supports required!</p><p>Designed to minimize filament use, while maintaining strength!</p><p>Entire print fits inside a single Prusa MK3 bed!</p><p>All perimeters are sized to perfectly print with two perimeters with zero infill! (except the base frame)</p><ol><li>Frame sits on counter</li><li>4x Pot holder sits on frame<ul><li>at a 4.7 degree angle</li><li>with standoffs, so water can run off easily under the pots</li><li>with spout on the “low” end, for water to drain out into a sink or receptacle.</li></ul></li><li>60mm Pots sit in the pot holder<ul><li>top of pots cut at same 4.7 degree angle, so they appear terraced.</li><li>pots have a tonne of drainage, no matter their orientation - but not too much that soil drops out!</li></ul></li></ol><p>The end result is when you water your succulents, the water magically drains into the sink.</p>