Sensor Box for Wemos D1 Mini, 18650 battery and T/H sensor

thingiverse

For some months now, I've been running pure DIY temperature + humidity sensors at home. They all are based on the same electronic design (Wemos D1 Mini, Wemos Battery Shield, additional resistor for voltage sensing and DHT22), and run a fully homemade firmware. Currently they all are hosted in poor recycled cardboard boxes; a pain in the... eyes. Thus I needed a custom casing that could house all these parts. This is my first design with Fusion 360, hope that will be ok... Sensor Casing has enough room for a Wemos D1 Mini (4x 2mm hole for screws), a 18650 Li-Ion battery holder and a simple sensor, such as DHT22 or SHT30. Height is around 3 cm in order to host a wemos-based 2 elements stack, such as D1 mini + battery shield. Print it, use it, enjoy it, and pls send your comments! **Update 2021/01/16** - *Added Smaller box* - original one is 90 x 80 x 35 mm (outer dimensions) - smaller one is 90 x 70 x 30 mm (outer dimensions)