Servo Mount Bracket for N Gauge Model Train Point Motors

thingiverse

Requirements * 1mm CSA wire * 2x M3x12mm bolts & nuts * 2x non-CSK wood screws, gauge 0 or 1 by 8mm This is a fairly rudimentary way of turning a servo into a point motor with minimal hassle and setup. Simply take some wire, poke it through the servo arm, bend it around so that it's relatively well secured, attach the whole thing to the board and bend a kink up through the hole for the point. All you'll need is a short length of wire (standard single core 1mm CSA mains cable would do, although 1mm stainless wire preferable) 2x M3 nut & bolt (12mm), and 2 small wood screws, non-countersunk. My configuration for printing is typically 30% infill with 3 layer wall thickness. I'm using bog standard Creality PLA. YMMV, I'm quite new to this.