SevenSwitch FET case

thingiverse

This is a simple case for the SevenSwitch http://reprap.org/wiki/SevenSwitch_1.2 I printed it in PLA using 0.2mm layers with no support. It prints fine, and clips closed with no need for screws or similar. Designed in DesignSpark, this is an original design, not based on any existing work. Other parts designed for my printers include: http://www.thingiverse.com/thing:1959901 (GT2 belt clamp (Prusa Y-axis) http://www.thingiverse.com/thing:1937232 (Arduino Mega and RAMPS v1.4 case) http://www.thingiverse.com/thing:1905409 (Prusa i3 steel 10mm upgrade) http://www.thingiverse.com/thing:1959974 (Prusa i3 Steel Y-axis motor mount) http://www.thingiverse.com/thing:1991116 (Prusa i3 Steel X-carriage) http://www.thingiverse.com/thing:1991117 (E3D Chimera / Cyclops mount) http://www.thingiverse.com/thing:1994413 (dual E3D Thermocouple amplifier board - housing) http://www.thingiverse.com/thing:1090661 (Belt driven Bowden extruder with 1:2.5 reduction) http://www.thingiverse.com/thing:896676 (enclosure for SevenSwitch FET) http://www.thingiverse.com/thing:922455 (8mm Z-axis leadscrew bearing holder) http://www.thingiverse.com/thing:922309 (Z-axis NEMA 17 adjustable endstop bracket) http://www.thingiverse.com/thing:899607 (cable chain) https://www.thingiverse.com/thing:2334269 (LCD housing) https://www.thingiverse.com/thing:2377049 (PSU cover) https://www.thingiverse.com/thing:2395715 (Chimera & Zesty Nimble drive cable spacer) https://www.thingiverse.com/thing:2407651 (Chimera Zesty Nimble X-axis set for i3 clone) https://www.thingiverse.com/thing:2436869 (A dummy NEMA 17 motor to hold the 5mm shaft) https://www.thingiverse.com/thing:2748978 (A Duet WiFi housing) https://www.thingiverse.com/thing:2749324 (A layer fan for the Smart Effector) https://www.thingiverse.com/thing:2814068 (A Sannce I21AG mount for 3D printers) https://www.thingiverse.com/thing:2844881 (A cooling duct for a Noctua 40mm fan on a Duet Smart Effector) https://www.thingiverse.com/thing:2846955 (A quiet BerdAir type pump mount) https://www.thingiverse.com/thing:3333609 (A Raspberry Pi case with 40mm fan) For avoidance of doubt, this item is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License. See http://creativecommons.org/licenses/by-nc-sa/4.0/ for more details.