Shampoo holder

thingiverse

A holder for a shampoo bottle to mount on top of a dornbracht hand shower outlet. The frame is 60x60mm just like the dornbracht rosettes are. Print Settings Rafts: Doesn't Matter Supports: Doesn't Matter Notes: I designed this so it should not be necessary to use supprort. After printing the two part glide perfectly into each other. I printed both parts with the top side down. I printed this with quite high layer height (0.25mm) because I was impatient... For the frame it is no problem, but for the holder I would go for higher resolution next time, to minimize the likelihood of water "hanging" in the steps caused by low resolution. How I Designed This I put a few thoughts into the design. I tried to minimize the surface contact to the platin of the dornbracht parts to avoid making marks. The underside of the grille is angled to guide waer away from the outlet. The ends of the water guides has "noses" so only very small drops will hang on.