Shampoo holder

prusaprinters

<p>A holder for two large (ø ~92mm ) shampoo and conditioner bottles to be squeezed onto two 12mm pipes.</p> <p>When I finished the design I realized it would require a lot of support material to print but I had lost interest in this model at that point so I just printed it that way. Be aware of this if you are going to print it (see pictures)</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>i3 MK2S</p></div><strong>Rafts:</strong></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div><strong>Resolution:</strong></p> <p>I used adaptive, but 0.2 would work fine</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>15%</p></div></p> <p><strong>Notes:</strong></p> <p>Printed in white PLA, maybe not the most suitable for water but it has worked for 4 months now.</p> <h3> Post-Printing</h3> <p>I added some rubber (purple parts) to prevent sliding on the pipes. I also added some m3 threaded brass inserts in the back plate by heating them up with a soldering iron and pressing them into the holes from the back. I then stuck the back plate behind the pipes and screwed the holder body into the back plate.</p> </p></p></p> Category: Bathroom