Shed 17 - Thomas

thingiverse

These are some models I created, inspired by "Shed 17", made by Pauls Vids on YouTube. The first model (printed in Ziro's Orange PLA) was the first version of the model I created. This model also used a 0.3 mm layer height, instead of the 0.2mm layer height used on the later model. The second model (printed in Sunlu's White PLA+) was my attempt to make the model more like the one featured in Pauls Vids' film. This includes internal organs, pelvis bones, a lower jaw and additional spine detail, all of which the original lacked. Both models printed just fine, however some if the support material, mainly the ones around the fragile skeletal part of the figure, were difficult to remove (though I guess this depends on your slicer program) where parts of the model (at both wrists and the base of the spine) snapped away from the rest of the model. In short, be very careful when removing these supports, just in case!