Shelf Headphone Holder Modified

thingiverse

After printing several of Cojones3's impressive designs for my coworkers, they asked if I could modify it to add a small lip to prevent headphones from slipping off. I also added a hook to hang cables neatly. The part that clamps onto the desk or shelf was surprisingly fragile even at 100% infill, so I reinforced it slightly. I'll post photos of the finished print once it's complete. Print Settings Printer Brand: Wanhao Printer: Wanhao Duplicator i3 V2 Rafts: No Supports: Yes Resolution: 0.25 Infill: 50% Notes: Scale down to one-tenth of the original size, I made an error by leaving them at ten times scale. Print the shelf clamp as shown in the render. Rotate the arch part 90 degrees so that its flat side faces the bed.