Shell & Memory Cards for Playstation Classic / Mini

prusaprinters

<p>2022.10.11: V6 has better measurements for the board mounting points and controller ports. Instead of screwing into plastic, this now has spots for metal M2 standoffs so standard M2 screws can be used to assemble the top and bottom halves of the shell. &nbsp;Standoffs will need to be glued into their slots. &nbsp;I've also added vents to the bottom of the shell to look closer to the original PS classic. Added models for the controller ports. Buttons will likely see refinement eventually</p><p>I did NOT scan the existing shell to make this - it has been replicated by looking at and caliper measuring the one I own.</p><p>This is meant to be a replacement shell, and should fit the existing board with M2 screws and existing heat sink. &nbsp;Added a cutout to the back with a flap that SHOULD snap in, to replicate the serial port / gameshark section. &nbsp;The PS classic shell uses M2.2 screws, which are very hard to replace - for that reason, I've made this shell to use a standard screw size. &nbsp;The sections where standoffs mount the board instead of screws should use a glued section of 1.75mm filament as pegs.</p><p>I have NOT gotten around to modeling the buttons, but those are simple cylinders - this is very much a work in progress.</p><p>&nbsp;</p>