Sherpa extruder adapter for delta printer (direct drive)

thingiverse

This is an adapter for sherpa extruder to fit on standart aluminum delta effector. As the motor did not fit, I needed to place the whole extruder with some angle (105°) and it works perfectly. Inside a standart PTFE tube is used to guide the plastic from sherpa to my volcano hotend. First I used a Capricorn 1.8mm tube, but later I switched to 2mm for the plastic to move easier. ----------Instruction------------ - print with 80-100 infill - place 4 brass M3*3*4 inserts. - Insert PTFE tube - put 2 M3 nuts to fasten your extruder - screw it with 4 M3 bolts using your radiator bracket (through effector)