Shield for 30 Minute Missions Portanova

thingiverse

I designed this 3D printed accessory that I called,Shield for 30 Minute Missions Portanova, for the purpose of customizing this model robot further by giving this model robot a Shield to defend himself with, and from the photos it looks very good with it. If you wish to download these files depending upon your 3D printer and your skill level with one, set your 3D printer accordingly, after you're done with that you may need a Dremel power tool or something similar to it with the right drill bits, some sandpaper, and some super glue, and from there the photos should show you how to put everything together, also you will need some super glue were the nozzle of the super glue is pointing at the bracket where the shaft is sticking out the bracket that will go between the shield and the lower arm of the model robot, you must do this to fill in the gap between the bracket and a lower arm so you we'll have to adjust it some so you'll be able to put it on the robots lower arm and remove it easily without it being too tight or too loose, and also so the 3D printed Shield will not fall off the arm, after that you're done the photos should show you the results, so enjoy.