Shift Knob for manual car

thingiverse

I couldn't find a shift knob that I liked at a price that I felt was reasonable. I printed this in ABS so that I could be chemically welded together. I used a flange nut with a 17mm hex head pressed into the bottom section and then JB welded into place. To add some mass to the knob I used 2 part 5 minute epoxy and BBs. If you want the knob to be heavier lead shot may work better. I don't have a scale, but the knob does have a good amount of heft to it. Once the epoxy cures use acetone to chemically weld the two halves together. .