Shower Head Wand Adapter - 30° angle, 5 cm higher

thingiverse

I wanted an adapter to raise and adjust the angle of my shower wand. It drops the angle 30° for less in-the-face and more top-of-head action and raises the whole thing up 5 cm because I'm not short. The dimensions of both the male and female portion of the adapter are as follows so you can see if it will work for your shower: Height - 28 mm Width at wide part - 23 mm Width at narrow part - 20 mm There are a few structural voids in inside the piece to increase the strength on low-density prints.