Shower Hose to Garden Spigot adapter

cults3d

This thing is an adapter that connects a standard shower massage wand to a standard garden hose spigot. I use it bathe my dogs and to rinse off after the pool. It looks a lot nicer than the kludge I used to use. I printed it in ABS at 100% infill for strength. When I tested it under pressure, a couple of pinhole leaks appeared, so I did a two hour acetone polish to make it water tight. I also did a quick hose washer that I printed in SemiFlex, but it was a little too stiff to seal properly so I ended up using a store bought washer. When I get some Ninjaflex, which is softer, I'll try the washer again.