Shutter box in three sizes

prusaprinters

<p>Containers with Shutter Lid for tools, small stuff or index cards A7 (Medium and Large Versions).</p><p>Dimensions (l/w/h cm):&nbsp;</p><ul><li>Small: 13.5 x 7.9 x 7.4</li><li>Medium: 15 x 12 x 10.4</li><li>Large: 20 x 12 x 10.4</li></ul><p>Also check out my other Shutter Lid Box models:</p><p>Piccolo (very small): &nbsp;<a href="https://www.printables.com/de/model/261544-shutter-lid-box-piccolo">https://www.printables.com/de/model/261544-shutter-lid-box-piccolo</a></p><p>Pen Case: <a href="https://www.printables.com/de/model/261162-pen-case-small-item-case-with-shutter-lid">https://www.printables.com/de/model/261162-pen-case-small-item-case-with-shutter-lid</a></p><p>This is a video of the Pen Case model, but the different models work pretty much the same.</p><figure class="media"><oembed url="https://youtu.be/HdKnU6-LLYw"></oembed></figure><p>&nbsp;</p><p>Print Instructions and Assembly:</p><ul><li>Print* all parts in PLA, completely and carefully remove support. All parts should fit snugly.</li><li>Use glue to assemble the box (I used universal glue for the bigger parts and super glue for the fragile/small parts).&nbsp;</li><li>First glue the separate side of the box into the side-part and then glue the two to the rest of the box. Make sure every thing lines up well and that there is no glue in the rails.&nbsp;</li><li>Weigh down until glue is dry.</li><li>Assemble shutter and end part and align the triangles neatly. Then glue the knob in place.&nbsp;</li><li>Once the glue on the box is properly dried, you may add a <i>little</i> silicone grease/spray to the rails. It will make the shutter run smoother.</li><li>Put the shutter in. Do this carefully while bending both the shutter and the box just a little bit. At first it might seem that the shutter is stuck and not moving well, but after &nbsp;opening and closing the box a few times the shutter should run smoothly and should be able to open and close it with just one hand.</li></ul><p><i>*</i>Print Instructions in .stl-File-Names. If you are using the .stl files you need to print the main body in two parts as in pictures (cut it at 3.5mm).</p><p>I already printed this a few times and improved it to the point where I think it is working very well. But please let me know if you have problems or suggestions to make it better.</p>