SIG/GSG 1911 +3 Magazine Follower

thingiverse

Replacement follower for stock gsg/sig 1911 single stack magazines. Adds +3 capacity for a total of 13. **Installation Instructions**: - Push original follower to the bottom of the magazine. - Push horizontal pin out through hole in the bottom of the examination window. - Push small screwdriver through hole on the base of the magazine, while depressing the internal pin, slide base off forwards (watch out that the spring doesn't jump out). - Remove original spring, follower and pin. Replace follower with 3d printed one, then reconstruct. - Horizontal pin should not be put back in (the 3d print does not even contain a hole for it), this is required as the new follower needs to move along a further range would be possible with the pin in-place.