Simple Camera Mount for Logitech C920 and Ender 3 Pro

thingiverse

This is an easy to print camera mount for a Logitech C920 (may work for other camera models that have the same bolt size) so it can be mounted from the front of an Ender 3 Pro. The camera screw was remixed from https://www.thingiverse.com/thing:578514 and a notch was added onto its side so it can be properly positioned inside of the base. **Note:** The camera screw may be a bit too wide if printed at full scale and so the default screw that comes with **camera_mount.stl** has been scaled down, diameter-wise by 2%. This reduced screw size worked for me. STL Descriptions: -------- - **camera_mount.stl** Here's everything you need to make the mount. Includes the base and a 2% reduced size screw. **Tip:** print at 0.24mm layer height for all layers, including first layer - **camera_base_only.stl** This is only the base - **camera_mount_screw_only_0.98size.stl** This is only the screw at 2% reduced size. It will take some work to get it in but it will most likely fit. Try **camera_mount_screw_only_1.0size.stl** if this size was too loose. - **camera_mount_screw_only_1.0size.stl** This is only the screw at full size. **Tip:** Don't use this one if you printed the base at 0.24 mm. Might work with smaller layer heights. Assembly and Installation: -------- 1. Print out both the base and the screw. 2. Place the screw into the bottom of your Logitech C920 camera. Twist it in until you have the notch facing to the back of the camera in a snug position (to the back means opposite from where the camera lens points). 3. Place the screw into the base. Press slowly downward until the screw is secure into the base. 4. Place the base onto the front of your Ender 3 Pro. (See the screenshots for guidance) Let me know if this works for everyone else! **Another Tip:** If you print this out with PLA and you twist the screw too hard, there's a chance that the screw will break. If it does, it's ok. Use your plastic cutters to twist the broken screw part out.