Simple Filament Spool Stand V3: easy-print remix

thingiverse

I changed the joint between stand and bar to have no overhangs less than 45° and made sure it prints nicely with a brim. For this I remodeled the whole thing in FreeCAD 0.13; file attached. Like the original this model is scalable. The provided STL prints to a height of 105mm. On the photos you see a print that was scaled by 1.7 in height and width, but not thickness. That's the largest my printer can handle and I still found the 8mm thickness of the stand sufficient. Just make sure to scale the bar accordingly. The bars are provided in 5 sizes (given dimensions are end-to-end). Instructions Recommended layer height: 0.3mm. 4-6mm brim highly recommended. 1mm perimeter and 20% - 30% honeycomb infill work for me.