Simple Lack Height Extender

prusaprinters

<p>I made this leg extender to raise my Ikea Lack enclosure up another ~200mm off the floor, because I wanted it higher for comfort and also I can then fit a small set of drawers under it for storing filament spools.</p> <p>Total height of the print is 220mm. It will raise the Lack table 205mm higher.</p> <p>Print upright without support - bridging gaps are only 12mm, a half decent printer should not struggle at all. I recommend printing with thick walls and low infill, there's hardly any room for infill anyway. I did 1.6mm walls and bottom thickness with 10% infill, and it is quite strong. I could push down with my whole body weight on a single one and it holds just fine.</p> <p>The extenders will need to be screwed to the Lack legs, drilling your own holes. As with any leg extender, these are going to introduce a bit of wobble. With each extender attached with two screws I found the wobble to be acceptable but your standards may vary.</p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>Ender 3</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>No</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>10%</p></div> <p><strong>Filament:</strong> Progressive3D PLA</p> </p></p> Category: 3D Printer Accessories