Simple LED strip light bar

prusaprinters

<p>This works well with all LED strip of 10mm in width.<br>The bar is 30 cm in length and is printed diagonally. The 30 cm in length matches the voltage "cut" lengths for far most LED strips.</p><p>The work is based on user “Gigante” on thingiverse, but was too narrow to fit most LED strips today - <a href="https://www.thingiverse.com/thing:3316724">https://www.thingiverse.com/thing:3316724</a></p><p>&nbsp;</p><h3><strong>Prusa mounting instructions</strong></h3><p>You can mount it backwards and it wont hit sample spool holder provided by prusament:<br><a href="https://www.prusaprinters.org/prints/51117-sample-spool-holder">https://www.prusaprinters.org/prints/51117-sample-spool-holder</a></p><p>Credit to the designers below.</p><p><strong>Mount:</strong><br><a href="https://www.thingiverse.com/thing:3268910">https://www.thingiverse.com/thing:3268910</a></p><p><strong>Cable clips:</strong><br><a href="https://www.prusaprinters.org/prints/16681-mk3-mk3s-cable-clip">https://www.prusaprinters.org/prints/16681-mk3-mk3s-cable-clip</a><br>(fits well and tight on the Prusa MK2/2.5/3 frame)</p><p><strong>Electronics:</strong><br>I've used a 24V to 12V converter mounted right above the PSU with double-side adhesive tape in a small case for the converter.&nbsp;<br>A similar converter can be found on &nbsp;for 24V to 5V LED strips.<br>Both can be found on AliExpress, eBay or Amazon.</p><p><i>NOTE:&nbsp;</i><br>MK2/2.5 uses 12V PSU - so you can run the LED directly from the Einsy board.<br>MK3 uses a 24V PSU - here you need a converter or a 24V LED strip.</p><p>&nbsp;</p><h3><strong>Print instructions</strong></h3><p>I have used PLA, but it is recommend to print the model with PETG or another high temperature resistant filament, due to the heat from the LEDs.</p><p>Nozzle size: 0.4 mm<br>Recommended layer height: 0.15 - 0.2 mm<br>Perimeter: 2<br>Infill: 15%<br>Supports: No</p>