Simple magnetic fan mount for titan aero

thingiverse

Here is a simple, compact and easy to use solution for mounting 5015 part cooling on titan aero heatsink. It is also easy to print with no supports and takes only 20-30 minutes. Originally designed for mirrored extruder version but can be mirrored in slicer to get it fit standard titan aero. Mounting plate is 2mm thick under the screw so it might require a longer screw to be used For assemply it requires 2 round magnets 15x2.75 mm, can be up to 3mm thick. Assembly - press magnet into place on the mount - apply couple drops of super glue onto the edge of the magnet to make sure it doesn't come out - press another magnet into the duct, make sure you do that with proper orientation, also as the duct wall is very thin you might want to put the duct flat onto the table to prevent tearing through that wall - install mount on the titan aero heatsink and ensure that the duct is attaching properly to the mount - install 5015 fan into the duct, it's tight fit so it doesn't require any screws or glue - put fan in place with satisfying click, you can try to wiggle it a bit to confirm that it sits sturdy enough and won't come off in the middle of the overnight print