Simple MakerFarm Z-Axis Anti-Backlash

thingiverse

To avoid backlash, I utilized auto bed levelling without disassembling anything. By employing this method, I've successfully completed a few prints with impressive results. The required components include two 5mm nuts and two springs. For installation, simply slide the spring and nut down the hole where the 5mm rod protrudes. Tighten the nut until you achieve your desired level of compression, then place the printed part over the nut to prevent further tightening during printing. Adjust the height of the part according to your spring for optimal performance; I used two springs that were 3/8 x 3/4 x .032 in size.