simple popsicle mold / parametric in OpenSCAD

thingiverse

There have been a few popsicle molds here before, but none were parametric in OpenSCAD. Sure, so many variables are confusing at first, but the script gives you the ability to change almost anything. You can make round ice cream but also flat ice cream. You can make small ice cream or big ice cream. The holder, which holds any number of molds, can be printed as a tray or, with a little glue, can also be used as a frame. The handle of the ice cream can be decorated with a small logo if it is in the same folder as a 1-bit vector graphic. Logo.svg TPU was found to work well for the mold. I use a cheap and relatively hard TPU. Popsicle stick and tray can then be made of PLA again. If you want to clean all this in a dishwasher, you have to use a heat-resistant filament such as nylon. If you want to make a circular ice cream, you should change these variables in the script. Ao= Do ; // distance above outside Au= Du ; // distance Below Outside It is possible to create lateral support walls and thus connect a lower tray to an upper holder. This creates a holder for the molds that looks like a test tube holder.