Simple Raspberry Pi bumper

thingiverse

A simple minimalist Raspberry Pi bumper (models 2 & 3 B as I recall) made to give the pi's some extra protection. Currently there's a basic version, a raspi cam version with space for the camera ribbon, a version granting access to the pins, and another cam version of this same design. Just pick your preferred top piece and snap it onto the bottom. Designed to be printed at 0.2 mm and assembled using snaps. Edit: The original base was about half a mm short up front; a new model is now available online. Edit: If you own an Anycubic Kossel, there's a clip here -> https://www.thingiverse.com/thing:3390812 that enables this bumper to be clipped onto the frame. Edit: As promised, versions allowing access to the pins have been added. Edit: For a 'case' version of this design, head over to https://www.thingiverse.com/thing:3427999 Also, Pro-tip: when disassembling this piece, use a spudger and remove the bottom first - it's less likely that the mating pins will break using this method.