Simple Sword Rack / Hanger / Bracket for Daisho Katana Wakizashi

prusaprinters

<p>I needed a wall-mounted hanger for a new daisho set that I bought, so i designed this. &nbsp;I thought most of the existing models seemed overly complicated or over-built. &nbsp;These are quick to print (about one hour and 40 minutes each), and are built to hold swords with up to about a 3" tsuba (which is pretty standard). &nbsp;Cost to print is about 42 cents each.</p><p>This should hold two swords with saya dimensions of up to 28 x 45mm. &nbsp; Mounts to the wall with 1 plain old deck screw. You will need two of these brackets. I installed mine about 14 inches apart. &nbsp;If you need to, use a wall anchor - don't install these directly into drywall without using wall anchors!</p><p>You will probably want to add a little strip of soft material to prevent chafing of the finish on the saya.</p><p>&nbsp;</p><p>I printed them at 15% infill, no supports at .24mm layer height in Matte Black PLA.</p><p>Designed in Fusion360, which once you get used to it, is pretty handy!:)</p>